Fully-bonded waterproofing membranes

Mapeproof FBT: one of the highly effective waterproofing chemicals against groundwater, moisture, and radon gas.

In March 2019, at the MADE trade fair in Milan, Mapei presented MAPEPROOF FBT, one of their new waterproofing products that creates a fully-bonded waterproof membrane for the first time. It generated a great deal of interest amongst sector operators.

The membrane, consisting of a layer of synthetic FPO firmly sandwiched to a non-woven fabric layer, was developed to waterproof reinforced concrete foundations. Once concrete has been poured, the membrane adheres monolithically to the concrete and remains bonded over time, impeding lateral water migration between the foundation structure and the membrane. In so doing, MAPEPROOF FBT forms a highly effective barrier against groundwater, moisture in the ground, radon gas, and methane.

Thanks to the waterproofing tapes MAPEPROOF FBT TAPE 600 and MAPEPROOF SA TAPE, Mapei offers proven waterproofing products that have demonstrated their effectiveness. 

The product was tested on the Swiss market where the Group's subsidiary, Mapei Suisse, introduced MAPEPROOF FBT in 2019 to widespread acclaim. Over the last two years, it has been installed on more than 270,000 m2 of surfaces: at the Swiss Life Arena site in Zurich, in the eco-neighborhood of Marly, and the swimming pool in Appenzell, as well as in entire neighborhoods, such as the Glasi district in Bülach and the Dietlimoos district in Adliswil. Mapei followed all these projects very closely and provided technical support, both when choosing which system to use and when installing the system.

we interviewed the engineer Philipp Truffer, owner of the engineering consulting company Truffer Ingenieurberatung AG and member of the Commission on Waterproofing Standards of the Swiss Society of Engineers and Architects (SIA).

Why should you use waterproofing products that create fully bonded membranes?

A waterproofing membrane fully bonded to fresh, poured concrete is thought of as an emergency solution for “white tank” systems. With white tank systems, it is not possible to exclude the possibility of localized leakage in advance, which then needs to be waterproofed by injection.

In such cases, you have to be able to reach the elements to be waterproofed, something that isn’t always possible, such as when plant equipment has been installed and it is difficult to remove it. In these situations, using a fully bonded membrane with a waterproofing chemical is a valid solution. It is also possible to combine it with a suitable system to waterproof the joints.

What are the advantages of this system compared with other types of membranes?

Being bonded to the concrete impedes the lateral migration of water. If the membrane does not adhere to concrete, it is not possible to localize potential leaks. The water would then pass through the waterproofing system and enter into the structure. Another advantage is the fact that, apart from guaranteeing excellent mechanical characteristics, the special polyolefin used to make the membrane can bridge any small deformations there may be in the structure of the concrete.

What is your experience with the Mapei systems?

We have always had positive results. We have found this type of waterproofing to be highly effective. However, because the devil is in the details, you have to be careful at all times, right down to the minutest part. Mapei supports us during the design phase by helping us determine the specifications for the work to be carried out. Application of the membrane is also important and has to be carried out by specialists who have received training specific to this type of work.

This article was taken from Realtà Mapei Suisse, no. 16, the in-house magazine published by Mapei Suisse/Schweiz.