PRODUCTS
MapePave

MapePave range

PUBLIC SPACES

LANDSCAPING

RESIDENTIAL BUILDINGS

SUITABLE FOR SURFACES USED BY VEHICLES

MapePave Range is intended to make it easier to lay natural and engineered stone pavers all year.

It includes a ready-to-use mortar system (MapePave Mortar and MapePave Slurry) that enables normal setting and regulated shrinkage for fast-drying bedding and installation of 20mm porcelain and natural stone.

MapePave Brush in Grout a single component ready-to-use polybutadiene-based drainage mortar for grouting paved floors with joints at least 5 mm wide.

Products in this line


MapePave Mortar

MapePave Mortar

Pre-blended, ready to use mortar with normal setting and controlled shrinkage for fast-drying bedding. Use in conjunction with MapePave Slurry.
MapePave Mortar is ideal for bedding 20mm porcelain, it is rapid curing (just 12 hours for foot traffic), rapid curing, thin application, with low shrinkage and is compliant with BS 7533. Pre-blended, just mix with water, to be used in conjunction with MapePave Slurry.

WALKABLE AFTER 12 HOURS

Mix ratio

Packaging: 25kg bags.
Consumption 15 kg/m² per cm of thickness.
MapePave Slurry

MapePave Slurry

Pre-blended, ready to use mortar, mixed with water for a paving slurry ideal for bonding 20mm porcelain. Use in conjunction with MapePave Mortar.
MapePave Slurry is a bonding agent to be used in conjunction with MapePave Mortar  for the rapid installation of exterior paving including 20mm porcelain.

WALKABLE AFTER 12 HOURS

Mix Ratio

Packaging: 20kg bags.
Consumption 15 kg/m² per cm of thickness.
MapePave Brush in Grout

MapePave Brush In Grout

One -component ready to-to-use polybutadiene-based drainage mortar for grouting paved floors with joints at least 5mm wide.
Grouting all types of external paved floors (porcelain slabs, cement-based composites, porphyry slabs and blocks, etc.) subject to light traffic (vehicles up to 3.5 tonnes).

JOINTING MORTAR

READY TO USE

LIGHT FOOT TRAFFIC AFTER 24 HOURS

EASY TO APPLY

Packaging: supplied in vacuum-packed 15kg drums.
Consumption depends on the width of the joints and the size of the slabs eg. where 600 x 600 x 20mm slabs are installed with a 5mm joint a 15kg drum of this product will cover approximately 25m .

technical-documentation-wBrochures, manuals, guides

Request a FREE sample 

Sample
Literature
Please select your choices:

News & Events

Mapei helps to protect HS2’s Westgate Headhouse

Back
October 11, 2024
Mapei solutions have been used to waterproof and protect fire control and ventilation systems at HS2’s Westgate Headhouse in West London.  The works on the Northolt Tunnel route were delivered by Byrne Bros for SCS JV. All Mapei products were supplied by BlueBay Building Products Ltd.
 
Situated adjacent to Hanger Lane roundabout, the Westgate Headhouse is sited at the top of a ventilation shaft which regulates air quality and temperature within the tunnel – 35 meters below – and, in the event of fire, allows extraction of smoke. Above ground, the rectangular headhouse contains fire control and ventilation systems for the railway tunnels below.  A green roof and landscaping along the line help the new structure blend into its surroundings.
 
Four Mapei products were used to waterproof and protect the headhouse and its contents.  Before pouring concrete, Mapeproof AL AP pre-applied, fully bonded, self-adhering HDPE waterproofing membrane was applied; upon contact with concrete, the robust membrane forms a monolithic bond.  Mapeproof AL 1200 AP – a HDPE self-adhesive waterproof membrane - was then post applied, followed by the application of waterproofing Mapeproof Liquid Membrane – a polyurethane elastomeric, thixotropic membrane used to seal, fill and detail. All of the concrete construction joints were made fully watertight with Idrostop 10 hydrophilic expanding rubber profiles.
 
Following the Westgate Headhouse installation, Mapei systems have also been specified by SCS across various HS2 sites in London. 


If you would like to be kept up to date with all the developments and industry news from Mapei UK.
Click here to sign up -  https://www.mapei.com/gb/en/newsletter

Waterproofing waterproofing polyurethane waterproofing Mapeproof polyurethane waterproofing waterproof membrane

Products mentioned in the article

MAPEPROOF AL AP
MAPEPROOF AL AP
Pre-applied, fully bonded, self-adhering, HDPE waterproofing membrane to protect against water underground structures Where to use:…
MAPEPROOF AL 1200 AP
MAPEPROOF AL 1200 AP
HDPE self-adhesive membrane to waterproof underground structures after pouring concrete
IDROSTOP
IDROSTOP
TECHNICAL DATA: Shape: pre-formed tape. Sizes available: 20x10 mm (IDROSTOP 10); 20x15 mm (IDROSTOP 15); 20x25 mm (IDROSTOP 25). Storage:…

Keep in touch

Subscribe to our newsletter to get Mapei news

SUBSCRIBE
SUBSCRIBE