Pultruded carbon fibre plate with a protective plastic film on both faces. TECHNICAL DATA: Modulus of elasticity: 170 - 200 - 250 GPa. Fibre content: 68% - 68% - 65%. Thickness: 1.4 mm. Width: 50,…
Pultruded carbon fibre plate with a protective plastic film on both faces.…
Pultruded carbon fibre tube impregnated with epoxy resin for reinforced stitching in masonry. TECHNICAL DATA: Tensile modulus of elasticity: 170,000 N/mm². Content of fibre by weight: 68%. Tensile…
Pultruded carbon fibre tube impregnated with epoxy resin for reinforced…
Two-component, super-fluid epoxy resin for injections and anchorings WHERE TO USE •Monolithic repair of structures with cracks or fissures caused by heavy loads, accidental impacts and earthquakes.…
Two-component, super-fluid epoxy resin for injections and anchorings WHERE TO…
Two-component epoxy resin with a very low viscosity for injecting into micro-cracks, also on wet surfaces. TECHNICAL DATA: Mixing ratio: comp. A : comp. B = 4 : 1. Pot life of mix: 35 minutes (at…
Two-component epoxy resin with a very low viscosity for injecting into…
Two-component, anti-corrosion cementitious mortar for steel reinforcement rods. TECHNICAL DATA: Maximum dimension of aggregate: 0.5 mm. Mixing ratio: comp. A : comp. B = 3 : 1. Pot life of mix:…
Two-component, anti-corrosion cementitious mortar for steel reinforcement rods.…
One-component, anti-corrosion cementitious mortar for steel reinforcement rods CO2 FULLY OFFSET PRODUCTS Mapefer 1K Zero is part of the CO2 Fully Offset in the Entire Life Cycle line of products. CO2…
One-component, anti-corrosion cementitious mortar for steel reinforcement rods…
Structural polymer fibres for concrete WHERE TO USE Mapefibre ST 50 Twisted are particularly suitable for the following: ·installation of industrial floors; ·production of pre-cast concrete panels…
Structural polymer fibres for concrete WHERE TO USE Mapefibre ST 50 Twisted are…
Keep in touch
