Back

ADESILEX PG1 ADESILEX PG2

Two-component thixotropic epoxy adhesives for structural bonding

WHERE TO USE

Structural repair, bonding and reinforcement of concrete elements, natural stone, mortar and brick with very low emissions of volatile organic compounds (EMICODE EC1 Plus).

TECHNICAL CHARACTERISTICS

Adesilex PG1 and Adesilex PG2 are two-component products based on epoxy resins, selected fine-grain aggregates and special additives according to a formula developed in MAPEI Research & Development laboratories.

After mixing Adesilex PG1 or Adesilex PG2 (part A) with their hardeners (part B), a thixotropic mix, easy to apply even on vertical structures in thicknesses up to 1 cm in a single layer, is obtained. Once prepared, Adesilex PG1 hardens by chemical reticulation alone in approx. 3 hours, while Adesilex PG2 hardens in 5 hours without shrinkage. They become compounds with exceptional bonding and mechanical strength.

Adesilex PG1 and Adesilex PG2 may also be applied on very damp surfaces as long as there is no standing water.

The products differ from each other in their working time. Adesilex PG1 is especially suitable for applications in temperatures between +5°C and +23°C, while Adesilex PG2 is recommended for higher temperatures.

Adesilex PG1 and Adesilex PG2 meet the requirements defined by EN 1504-9 (“Products and systems for the protection and repair of concrete structures - Definitions, requirements, quality control and evaluation of conformity – General principles for the use of products”) and the minimum requirements claimed by EN 1504-4 (“Structural bonding”).

CONSUMPTION

1.65-1.75 kg/m² per mm of thickness.

PACKAGING

Adesilex PG1

2 kg kit (comp. A: 1.5 kg; comp. B: 0.5 kg).

6 kg kit (comp. A: 4.5 kg; comp. B: 1.5 kg).

Adesilex PG2

6 kg kit (comp. A: 4.5 kg; part B: 1.5 kg).